Kenwood KDV-5234 - Manual (Page 44)

44 KDV-5234
4 Exit audio setup
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
DISP /PTY
SW
AME TI FM SCRL
SRC
• If a volume offset is set for each source with "V-OFF", the
volume will be nearly the same for all sources when the
source is changed.
• When "2ZON" is ON ("DVD"/"AUX"), you can only set "V-
OFF" and "LOUD".
• If the dual zone function is used, different sources can be
output from the front speakers (source of this unit) and
the rear speakers (disc source of this unit or the sound
input to the built-in AUX).
• For "LPF" and "PHAS", the feature "SWPRE" needs to be
set to "SW" (subwoofer) in advance in the menu setup,
and the subwoofer output to ON. For details on how to
set up "SWPRE", refer to
• "PHAS" cannot be set up when "LPF" is set to "THRU".
• "AVOUT" can be set when the feature "SWPRE" in
setup> (page 50) is set to "AV".
Speaker setup
Fine adjust the System Q value to the speakers.
1 Set to STANDBY mode
Q AM SETUP AUD
VOL
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
OFF
DISP /PTY
SW
SRC
STANDBY
Select "STANDBY".
2 Set to the speaker matching mode
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
DISP /PTY
SW
AME TI FM SCRL
SRC
Audio setup
Sets up volume offset, dual zone function, etc.
1 Start audio setup
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
DISP /PTY
SW
AME TI FM SCRL
SRC
2 Select features to set
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
DISP /PTY
SW
AME TI FM SCRL
SRC
Each time the knob is rotated, the type
changes in the following order.
Feature Setting range
HPF Specifies the front high-pass filter cutoff
frequency.
HPR Specifies the rear high-pass filter cutoff
frequency.
LPF Specifies the low-pass filter cutoff frequency.
PHAS Specifies the subwoofer phase.
V-OFF Adjusts the volume difference between sources.
LOUD Corrects treble and bass when the volume is low.
AVOUT Specifies the output level of the AV OUT terminal.
2ZON Turns the dual zone function ON/OFF.
3 Set up each feature
Q AM SETUP AUD
VOL
ATT
MENU SCAN STOP M/S RDM REP F.SEL M.RDM
DISP /PTY
SW
AME TI FM SCRL
SRC
The setting range of each item is as follows:
Features Setting range
HPF/HPR THRU (Filter Off)/40/60/80/100/120/150/
180/220 (Hz)
LPF 50/60/80/100/120 (Hz)/THRU (Filter Off)
PHAS REV (180˚)/NML (0˚)
V-OFF -8 – 0
LOUD OFF/ON
AVOUT -15 – 0
2ZON OFF/DVD/AUX
Audio Control