Kenwood D-S300 - Manual (Page 5)

5
D-S300 (En)
Connection to a general-use amplifier
Use the provided audio cords to connect the OUTPUT jacks of this
unit to the CD input jacks (or AUX jacks) of the amplifier.
Connection to digital amplifier or MD
Connect the DIGITAL OUTPUT (OPTICAL or COAXIAL) jack to the
digital input jack of the amplifier, DAT recorder, MD recorder, etc.,
using an optical fiber cable or coaxial cable which are commercially
available in audio stores.
÷
When using an optical fiber cable to connect this unit to a digital
amplifier, insert the plug straight into the jack until a snap sound is
heard.
÷
Be careful not to bend, coil, or bundle the optical fiber cable.
÷
Optical fiber cables available on the market may not always be able to
be used with this player. If your cord cannot be used with this unit,
consult the store from which you purchased the cord or your nearest
dealer.
Optical fiber cable
SYSTEM CONTROL OPERATIONS
Remote Control
Lets you operate this unit with the system remote control unit supplied with the AV CONTROL CENTER or receiver.
Automatic Operation
Automatically switches the input selector on the AV CONTROL CENTER or receiver when you start playback from this unit.
Synchronized Recording
Lets you synchronize recording with the start of playback when recording from CD. Also, the simple CCRS operation and O.T.E. recording lets you
make great recordings from CD.
See the operating instructions supplied with your cassette deck for details.
SYSTEM CONTROL CONNECTIONS
After hooking this unit up with the KENWOOD System “SERIES 21,” connect the system control cords for convenient system control
operations between the connected devices.
When hooking this unit up with the System “SERIES 21,” read the instruction manuals supplied with the AV CONTROL CENTER (sold
separately) or the receiver (sold separately).
Notes Notes
1. Do not connect system control cords to any components other than
those specified by KENWOOD. It may cause a malfunction and dam-
age your equipment.
2. Be sure the system control plugs are inserted all the way in to the
system control terminals.
System connections