Kenwood D-S300 - Manual (Page 25)

2 5
D-S300 (En)
÷
Insert the power plug firmly to the AC outlet.
÷
Turn the amplifier’s power ON.
÷
Load the disc again with its label side up.
÷ Insert the disc properly.
÷ Wipe off the dust on the surface of the disc
referring to ”Disc handling precautions“.
¢
÷ Replace the disc with a new one.
÷ Leave the player for about 1 hour so that the
condensation is removed.
¢
÷ Press the 6 key.
÷ Wipe off the dust on the disc surface referring
to ”Disc handling precautions“.
¢
÷
Replace the disc with a new one.
÷ Connect all connection cords firmly.
÷
Wipe off the dust on the disc surface referring
to ”Disc handling precautions“.
¢
÷
Replace the disc with a new one.
÷
Try selecting a place where no strong vibra-
tions occur by changing the installation place,
etc.
÷
Power plug is loosely connected.
÷
With the power plug connected to the switched
AC outlet of an amplifier, the power of the
amplifier is turned off.
÷
Disc is loaded upside down.
÷ Disc is loose.
÷ Disc is dirty.
÷ Disc is cracked.
÷ Condensation has occurred on the optical lens
unit.
÷ Play mode is not entered.
÷ Disc is too dirty.
÷
Disc is cracked.
÷ The connection cords are inserted loosely.
÷
Disc is too dirty.
÷
Disc is cracked.
÷
Oscillation is applied to this unit.
In case of difficulty
What appears to be a malfunction may not always be serious. If your unit should not perform as expected, consult the
table below to see if the problem can be corrected before seeking help from your dealer or service representative.
Operation to reset
The microcomputer may fall into malfunction (impossibil-
ity to operate, erroneous display, etc.) when the connec-
tion cords are unplugged while unit is ON or due to an
external factor. In this case, execute the following method
to reset the microcomputer and return it to normal condi-
tion.
Unplug the power cord from the power socket and plug
the power cord into the socket again.
÷ Please be aware that resetting the CD player will erase all stored
information and return it to the factory settings.
Symptom Cause Remedy
CD player unit
The unit is not turned ON with the ON/
STANDBY(
) key ON.
Disc is loaded, player does not play.
No sound.
Music is interrupted. (Sound is skipped.)