Kenwood D-S300 - Manual (Page 16)

D-S300 (En)
1 6
Programmed play (PGM mode)
Use the following procedure to program desired tracks in a
desired order. (up to 32 tracks)
÷
Load a disc in the CD player.
÷
Set the INPUT SELECTOR to ”CD“ on the
connected device such as AV CONTROL
CENTER or receiver.
Press so that the “PGM” indicator lights.
1
Preparation
: Keys and control used in the operations described on this page.
G P 0 M 1 N T . O ? ?
Blinks.
MULTIPLE CD PLAYER D-S300
ENTER
GRC operation RC operation
To stop playback
÷ When the 4 or ¢ key is pressed during playback, the track will be
skipped in the direction of the pressed button.
÷ When the 4 key is pressed once during playback, the play position
returns to the beginning of the current track being played.
GRC operation RC operation
6
2
1
Select the desired track No.
Press the numeric keys as shown below....
To enter track No. 25:
005
2
Set the entry.
P.MODE
P.mode
ENTER
Go to step
2
within 8 seconds.
÷ Tracks can also be selected by pressing the 4 or ¢ key.
÷
Up to 32 tracks can be programmed. When “ FULL” is displayed, no
more tracks can be programmed.
÷
If you make a mistake, press the CLEAR key and enter the track No.
from the beginning.
÷
When the total playing time of the programmed tracks exceeds 100
minutes, the remaining time on the disc will not be displayed any more.
G P 0 M 1 N T . O 5 2
3
Repeat steps 1 and 2 above.
PGM
Mode
P.mode
ENTER
ENTER
ENTER
Do this operation in the stop mode.
P.MODE
GRC operation RC operation
RC operation
Start playback.
Press the ENTER key after selecting each numeric icon.
#
+10
5 4 3 2 1
0 9 8 7 6
1 2 3
4 5 6
7 8 9
0 +10
ENTER
GRC operation
G P 0 M 1 N T . O 5 2 AB
«
G P 0 M 1 B A D C F E H G
In the case of a CD-TEXT disc, the track’s title is scrolled on the display.
÷ The programmed contents remain in memory.
7
Program desired tracks.
ENTER
3
GRC operation : Complete the procedure in “Basic Operations
for the Graphical Remote Control Unit (GRC)”
90