Kenwood D-S300 - Manual (Page 27)

2 7
D-S300 (En)
Specifications
[ Format ]
System ......................................................................... Compact disc digital audio system
Laser ..................................................................................................... Semiconductor laser
[ D/A Convertors ]
D/A Conversion ............................................................................................ 1 Bit (D.R.I.V.E.)
Oversampling ................................................................................................ 8 fs (352.8 kHz)
[ Audio ]
Frequency response .......................................................................... 4 Hz – 20 kHz,
±
0.5 dB
Signal to noise ratio ................................................................................. More than 100 dB
Dynamic range ........................................................................................... More than 93 dB
Total harmonic distortion + noise .......................................... Less than 0.005% (at 1 kHz)
Channel separation ................................................................... More than 93 dB (at 1 kHz)
Wow & flutter ....................................................................................... Unmeasurable Limit
Output level/impedance
Variable ............................................................................................ (Max.) 1.2 V/0.3 k
Ω
Digital output
Coaxial ................................................................................................... 0.5 V p-p / 75
Ω
Optical ........................................................................................... –15 dBm – –21 dBm
(Wave length 660 nm)
[ General ]
Power consumption ....................................................................................................... 12 W
Dimensions
W: 400 mm (15-3/4")
H: 106 mm (4-3/16")
D:
376 mm (14-13/16")
Weight (Net) ..................................................................................................... 3.9 kg (8.6 lb)
For the U.S.A.
FCC WARNING:
This equipment may generate or use radio frequency energy. Changes or modifications to this equipment may cause harmful interference unless the
modifications are expressly approved in the instruction manual. The user could lose the authority to operate this equipment if an unauthorized change
or modification is made.
NOTE:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a residential installation. This equipment may cause harmful interference to
radio communications, if it is not installed and used in accordance with the instructions. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver in connected.
– Consult the dealer or an experienced radio/TV technician for help.
1. KENWOOD follows a policy of continuous advancements in development. For this reason specifications may be changed without notice.
2. The full performance may not be exhibited in an extremely cold location (under a water-freezing temperature).
Notes Notes