Kodak DP1100 - Manual (Page 13)

Connecting the Projector
3/99 9
ENGLI
S
H
Connecting to a Video Player
If your video player uses a round, one-prong composite video
connector, you need only the A/V cable that was shipped with the
projector. If your video player uses a round, four-prong S-video
connector, you need an S-video cable in addition to the
A/V cable.
Note: The S-video cable is sold separately. To order the cable,
refer to the Reference Manual.
Connecting with an AV Cable
1. Plug the A/V cable’s yellow connector into the “video-out”
port on your video player. This port may be labeled “To
Monitor.”
2. Plug the other yellow connector into the composite connector
on the back of the projector.
3. Plug the A/V cable’s white connector into the left “audio out”
port on your video player. Plug the cable’s red connector into
the right “audio out” port on the video player.
4. Plug the A/V cable’s other white and red connectors to the left
and right “audio in” ports on the projector.
To start using your projector, go to “Starting the Projector” on
page 11.
audio/video cable