Kenwood KRF-X9080D - Manual (Page 41)

41 EN
ENGLISH
Basic remote control operations for other components
Storing the remote control code of the other
components
The remote control unit can store the remote control code of the other
components and you can operate the other components from the remote
control unit. The remote control code is stored on the key or memory of
the remote control unit.
Storing on the key
You can store the remote control code to the key as shown below:
S R C Po we
r TV
Pow er
5
6
8
9
4
3
2
1
0
7
Tune – Tune +
Dimmer
Band
Setup
Top Menu Auto
Info / Flip
Input
Mode
Loudness
Active
EQ
Speaker
EQ
Sound
Tone
TV Input Bass
Boost TV
VOL
4
¢
CH
+
–
VOL
+
–
Disc Skip Menu
Input Sel.
OSD
Guide
Return
Exit
Page
TV Mute
Last / AB
+ 10 + 100
Multi
Multi
P. Call
P. Call
Enter
TV PHONO POWER
RCVR
VID2
VID1 DVD
6CH CD
DVD
MD
TAPE
+ –
TUNER
AV AUX VID3
Stereo
Listen Mode
THX Learn
Mute Disc Sel.
DSP
Mode
Numeric keys
Source keys
Last / AB
LCD
SRC Power
Return
Disc Sel.
Disc Skip
CH +/–
Skip ¢/4
¡Rewind
1Fast forward
3/8Play/Pause
2Info/Flip
7Stop
Learn
OSD
Menu
Page ∞/5
RDS Disp. PTY
1
Point the infrared ray system part of another remote control
unit to the remote sensor of the remote control unit.
2
Press and hold the Learn key for 3 seconds until blinks
twice, then release the Learn key.
3
Press the numeric key to enter 9 , 7 , 5 .
4
Press any of the source keys (PHONO, VID1, VID2, VID3, DVD/
6CH, AV AUX, CD/DVD, MD/TAPE, TV ) to select the input of the
desired remote control unit.
• While in Tuner mode, learning code function will not be available.
5
Press the desired key of the remote control unit.
• “LEARN” appears on the display.
6
From the remote control unit of the other source, press the key
that you want to store.
• The remote control code is sent to the remote control unit.
• “OK” appears when finished.
• If the code cannot be stored after a few attempts, “ERROR” will
appear. Repeat from step 2 onwards.
7
The remote control code is stored on the key of this remote
control unit.
8
Repeat step 4 to 6 to store additional components until all
the desired components are stored.
9
To exit the learning mode, press and hold the Learn key for 3
seconds until
blinks twice.
0
To clear the stored remote control code of the other sources:
1 Press and hold the Learn key for 3 seconds until blinks twice,
then release the Learn key.
2 Press the numeric key to enter 9 , 7 , 6 .
3 Press the Source key, then press the stored key twice until
blinks twice.
•
blinks twice to indicate that the stored remote control code are
deleted.
Remote control
unit of the other
source.
Infrared ray system part
04.6.16, 3:57 PM 41