Samsung NX-308 - Manual (Page 51)

line, trunk group, or Speed-Dial number whenever the station goes off-hook. A
hot line delay time of 1 to 9 seconds can be programmed to allow sufficient time
to make a different call.
➥
MMC 25 HOT/WARM LINE
IN GROUP / OUT OF GROUP
Individuals assigned to a station hunt group may temporarily remove their
telephones from the group by pressing the IOG button. Stations out of a group
will not receive calls to that group but will continue to receive calls to their
individual extension numbers. When desired, the user may put him/herself back
into the group by pressing the button again. Users who do not have this button
may dial an access code.
➥
MMC 70 DIAL NUMBERING PLAN IOG: 53
➥
MMC 71 SYSTEM KEY PROGRAMMING
➥
MMC 72 STATION KEY PROGRAMMING
INCOMING CALL DISTRIBUTION
Incoming calls can be assigned to ring a distributed station hunt group. This will
allow all members of the group to share the call load.
➥
MMC 35 ASSIGN STATION GROUP
➥
MMC 43 ASSIGN TRUNK RING
INCOMING / OUTGOING SERVICE
Programming allows any outside line to be used for incoming calls only, outgoing
calls only, or both.
➥
MMC 31 EXT/TRK USE
INDIVIDUAL LINE CONTROL
Each station in the system can be programmed to allow or deny dialing out.
Each outside line may be programmed to allow or deny answering.
➥
MMC 31 EXT/TRK USE
LIVE SYSTEM PROGRAMMING
The system can be programmed from any display keyset without interrupting
normal system operation. There are three levels of system MMC programming:
Technician, Customer, and Station.
➥
MMC 20 OPEN PROGRAMMING
➥
MMC 21 CHANGE PASSCODE
TECHNICIAN LEVEL
The Technician level has access to all programs via the Technician
NX-SERIES HYBRID KEY SYSTEM FEATURES SECTION
3 - 8