Troubleshooting guide – Kenwood KDC-M9021 EN User Manual
Page 47
— 47 —
— 47 —
?
Can’t enter Album Select mode.
101
✔ There’s no folder recorded in the MP3/WMA media.
☞ Use a media with levels.
?
The songs in the selected folder aren’t played in Album Select
mode.
102
✔ There are no MP3/WMA in the selected folder.
☞ Make sure there’s recorded content in the MP3/WMA media.
?
The MP3/WMA track/album search takes time.
78
✔ Many tracks are recorded on the media.
☞ When the media directory is complex, the track/album search can
take time.
?
The MP3/WMA related text isn’t displayed correctly.
79
✔ A character is entered that this unit can't display.
☞ For the characters that can be used for MP3/WMA text entry,
refer to
?
The MP3/WMA track time isn’t displayed correctly.
80
✔ ---
☞ There are times when it isn’t displayed correctly according to the
MP3/WMA recording conditions.
If the following situations, consult your nearest service
center:
• Even though the disc changer is connected, the Disc Changer source is
not ON, with "AUX" showing in the display during the Changer Mode.
• Even though no device (KCA-S210A, CA-C1AX, KDC-CPS87, KDC-CX87,
KDC-CPS85, KDC-CX85, KDC-CPS82 or KDC-CX82) is connected, the
Auxiliary input is entered when switching modes.
Troubleshooting Guide
The messages shown below display your systems
condition.
Eject:
No disc magazine has been loaded in the changer.
The disc magazine is not completely loaded.
E01
➪
Load the disc magazine properly.
No CD in the unit.
➪
Insert the CD.
No Disc:
No disc has been loaded in the disc magazine.
E02
➪
Load a disc into the disc magazine.
TOC Error:
The CD is quite dirty. The CD is upside-down. The CD
is scratched a lot.
➪
Clean the CD and load it correctly.
E-05:
The CD is upside-down.
E05
➪
Load the CD correctly.
Blank Disc:
Nothing has been recorded on the MD.
E10
No Track Disc: No tracks are recorded on the MD, although it has a
title.
E11
No Music Data: Media was played that doesn’t have data recorded
that the unit can play.
E15
➪
Use media that has data recorded that the unit
can play.
No Panel:
The faceplate of the slave unit being connected to
this unit has been removed.
E30
➪
Replace it.
E-77:
The unit is malfunctioning for some reason.
E77
➪
Press the reset button on the unit. If the "E-77"
code does not disappear, consult your nearest
service center.
KDC-M9021SE_U.S 03.1.17 3:20 PM Page 47