Kodak DC25 - Manual (Page 12)

2-2
Battery Indicators
You may also check the battery level from the STATUS display on the LCD.
See the
LCD section of this chapter entitled Checking Camera Status for
instructions on accessing the STATUS display.
The DC25 may unexpectedly power off if the batteries have reached a low point
and the batteries will need to be replaced. If the batteries should go dead while
pictures are stored in the camera’s memory or Picture Card, the pictures remain
stored in the camera.
Resolution Mode
You may set your DC25 to capture pictures in a High or Standard resolution.
Your pictures include more detail with high resolution, but they will use more
memory in the DC25 than standard resolution pictures.
You can switch freely between the two settings when taking pictures. The
number of pictures the DC25 is able to store will vary accordingly.
The green Power light, on the back of the DC25, blinks to
indicate that the battery is weak and in need of replacement.
High— you can take
approximately 14 pictures at
493 X 373 pixels.
Standard— you can take
approximately 29 pictures at
320 X 240 pixels.
Power
Busy
Memory
ERASE POWER
OFF AUTO FILL
STANDARD HIGH
KODAK DC25 DIGITAL CAMERA
Resolution switch