Kenwood TH78E - Manual (Page 25)

2 Press the F key, then the 0/L.OUT key.
A * indicator appears below the memory channel
number on the display, indicating that channel will be
skipped in the memory channel scan mode.
3 Repeat steps 1 and 2 to lockout any other channels
you may want to skip.
4 To cancel the lockout, select the memory channel
number. If it was locked out, it will have the *
indicator on the display.
Press the F key and then the 0/L.OUT key. The *
will disappear.
5 Band scan
1 Adjust the SQL control to the threshold point.
2 Press the Band key to select the desired Scanning
Band.
3 Press the VFO key to select the VFO mode.
4 Press and hold the VFO key for longer than one
second.
Scanning begins toward the higher frequencies. The
MHz indicator (decimal) flashes when the transceiver
is scanning.
5 Scanning pauses on a station strong enough to open
the squelch and turn the BUSY indicator on.
t
6 Programmable Band Scan
This transceiver can select and scan a frequency
range in a band.
You can set separate limits for both VHF and UHF,
limiting dual scan on both bands.
Even if you sets the programmable band scan limits,
the VFO tuning range is not limited unlike the
programmable VFO function. (See page 15.)
For example, you can program so that the
transceiver scans a range from 144.50 to 145.80 in
the VHF band.
Use the following procedure to specify the desired
scan limit.
1 Press the BAND key to select the desired Band.
2 Select the desired upper scan limit.
3 Press and hold the M key for longer than one
second, then press the 5 key.
4 Select the desired lower scan limit.
26