Kenwood TH78E - Manual (Page 22)

10 Memory Channel Character Display
You can display the memory channel frequency with
your own spelling. It may be up to six characters
long. You can use numerics 0 to 9 and the letters A
4 Enter your message with the keypad. See the list on
page 45 for the key combinations for each letter.
5 If you enter the wrong message, press the VFO key
to start over step 4.
to z.
Function Setting
Press and hold the f² key, and turn the power on.
Note
When you select this function, the memory channel
can be displayed alphanumerically, but the total
number of available memory channels is halved, i.
e., 25.
To return to 50 channels, repeat the operation.
Character registration
If you want to display the memory channel number,
press and hold the F key for longer than one second,
then press the f² key.
Message Display Cancel
1 Select the memory channel to be canceled.
6 Press the MR key at the end.
7 You can display a message from other memory
channel by performing steps 2 to 6 again.
Note
A message can be displayed for a maximum of 25
memory channels.
If a message is specified for a memory channel, the
message is displayed instead of the memory channel
number.
1 Press the MR key to enter the memory channel
mode.
2 Select a desired channel from among the memory
channels in which you stored data using the Tuning
control or numeric keypad.
_
3 Press the M key, then press the f² key to enter the
2 Press and hold the M key for longer than one
message setting mode.
second, then press the f² key.
The message display is canceled, and the memory
channel is displayed.
23