Kenwood DV-4070 - Manual (Page 32)

Settings
32
Chapter 2: Various Setups
"Audio During Search" Setting
During DVD or VCD search at the first speed step, this
setting makes it possible to select whether the
reproduced audio is output or not.
At the factory, the player has been set to "On" for
outputting the reproduced audio during search.
Setting items
" " : Select to return to the previous screen.
"On" : Select to output audio during search.
"Off" : Select to mute audio during search.
Operation procedure
1. Set the mode switch of the joystick remote to the
Purple position.
2. While the player is in stop mode, press
SET UP
1 and
tilt the joystick up or down to display the "SOUND"
menu of "SET UP MENU".
3. Press ENTER to open the setup screen.
4. In the setup menu, select "Audio During Search"
by tilting the joystick up or down and press ENTER .
7 On
7 Off
7 Digital Audio
Dolby Digital
Speaker Setting
Audio During Search
Dynamic Range Control
Audio Filter
DTS
MPEG
PCM Down Conversion
5. Select "On" or "Off" by tilting the joystick up or
down, then press ENTER to enter the selection in
memory.
"Dynamic Range Control"
Setting
When playing a DVD recorded with Dolby Digital
Surround, set the dynamic range control according to
the software being played. For instance, when the
words are hard to be listened to due to effects sound
in a move, this setting makes it possible to adjust the
volume level of only the low-level sound and can
reduce repetition of complicated volume level
adjustments.
At the factory, the player has been set to "Wide" with
which the audio levels recorded in discs are reproduced
as they are.
Setting items
" " : Select to return to the previous screen.
"Wide" : Select to reproduced the audio at the level
recorded in the disc.
"Normal" : Select to reduce the difference between
the maximum and minimum volume levels.
"Midnight" : Select to further reduce the difference
between the maximum and minimum volume
levels. This setting is suitable for low-level
listening in late at night, etc.