Kenwood DV-4070 - Manual (Page 31)

Settings
31
к›Е@нЛЕ@п“
Chapter 2: Various Setups
[Subwoofer setting]
0 dB
dB
0 dB
0 ms
0 ms 0 dB 0 dB
-5 -4 -3 -2 -1 +1 +2 +3 +4 +5 +6
LS
R
RS
L
SW
C
SW
-6 0
Speaker Setting
Level
Exit
Size Off On
Use of subwoofer: Select "Off" if the subwoofer
is not used.
Level: Set the volume level.
After completing the speaker setting, select "Exit"
to enter the setting and return to the screen in
step 5.
7. After completing the speaker settings, select "Test"
by tilting the joystick up/down or to the left/right
and press ENTER . The cursor will automatically move
across the speakers in sequence from "L" and the
test tone is output from each speaker indicated by
the cursor.
Press ENTER again to display the speaker setting
screen for the speaker being indicated by the cursor.
¶ The cursor skips the subwoofer and the speakers
set to "Off" and test tone is not output from
them.
¶ After adjusting the level of each speaker channel
by tilting the joystick to the left or right, press
the ENTER button, then select "Exit" and press
the ENTER button to restart the test tone output.
Repeat the volume level adjustment until the
volumes of all speakers are identical.
¶ When the joystick is tilted in any direction during
the test tone output, the test tone output stops.
(The same effect can also be obtained by pressing
the RETURN button)
8. After completing the speaker setting, select "Exit"
and press ENTER to enter the setting in memory.
¶ As the test tone is not output from the subwoofer,
its volume level should be adjusted after listening
to the actual sound.
[Surround speakers setting]
0 dB
dB
0 dB
0 ms
0 ms 0 dB 0 dB
-6 -5 -4 -3 -2 -1 0 +1 +2 +3 +4 +5 +6
LS
R
RS
L
SW
C
LS
Speaker Setting
Level
Delay Time
Exit
Off Size Normal Large
ms 0 5.3 10.6 15.9
Size: Select "Normal" when the connected speaker
is incapable of reproducing audio below 100 Hz.
Select "Large" when the connected speaker can
reproduce audio below 100 Hz.
Use of surround speaker: Select "Off" if the
surround speaker is not used.
Level: Set the volume level.
Delay Time: Set the delay time. For the setting
value, see "Delay Time Setting".
After completing the speaker setting, select "Exit"
to enter the setting and return to the screen in
step 5.