Kenwood KRF-V4550D - Manual (Page 18)

18
Operations
Normal playback
1
Listening to a source component Adjusting the sound
Adjusting the tone
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo mode.
1 Press the SOUND key to select the tone mode to be adjusted.
• The bass and treble levels are adjustable from -10 to +10 in 2 step
increments.
• The adjustment item is displayed for approximately 8 seconds.
Use the INPUT SELECTOR to select the source you want to
listen to.
2 Use the MULTI CONTROL to adjust the sound quality.
BASS: Select this to adjust the low frequency range.
(Press the SOUND key once.)
TREB: Select this to adjust the high frequency range.
(Press the SOUND key twice.)
Once-touch low frequency emphasis (bass boost)
You can adjust the sound quality when the receiver is in the PCM stereo
and analog stereo mode.
Press the BASS BOOST key.
• Press the key once to select the maximum (+10) low frequency
emphasis setting.
• This key does not function when the receiver is in the sound quality
or ambience effects adjustment mode.
Switching back to the previous setting
Press the BASS BOOST key again.
FM
AM
MHz
kHz
PRO LOGIC
3
DOWN MIX
DIGITAL
S.DIRECT
MONITOR
DSP
MEMO
ST.
TUNED
AUTO SOUND AUTO
LFE
C
S RS LS
TI.VOL B
CLIP MUTE
RDS EON PTY
TP TA NEWS
SW
L SP R
STEREO
1 "PHONO"
2 "TUNER"
3 "CD/DVD"
4 "TAPE" or "MD"
5 "VIDEO1"
6 "VIDEO2"
7 "DVD/6ch"
Selecting VIDEO 2/MONITOR
Depending on the component connected to the VIDEO 2/MONITOR
jacks, select either the "VIDEO 2" setting or the "MONITOR" setting, as
appropriate.
7
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob
INPUT SELECTOR
VOLUME CONTROL
INPUT
SELECTOR
VOLUME
SOUND
VOLUME CONTROL
SOURCE DIRECT
PHONES
MULTI CONTROL
VOLUME
SOUND
MUTE
BASS BOOST
MULTI
CONTROL
SPEAKER
MUTE
2
3
Start playback from the selected source.
Use the VOLUME CONTROL knob (VOLUME keys) to adjust
the volume.
*4967/01-/EN 3/19/01, 6:34 PM 18