Kenwood HM-537MP - Manual (Page 9)

9 EN
Using the CD/MP3-CD
Loading a disc
1 Press CD button to select CD/MP3 mode.
2 Press 0 open/close button to open the CD
tray.
3 Place a CD/MP3 into the tray with the label
facing up.
4 Press 0 open/close button to close the CD
tray.
The total playtime and total number of tracks
will appear in the display.
5 To remove the CD, press 0 open/close but-
ton, grasp the CD by its edges, and carefully
pull it out.
For MP3-CD only
Load a MP3 format music disc on the disc tray.
• The total album number and total track number
will appear on the display.
Notes:
• To ensure good system performance; wait until the
unit completely reads the disc before proceeding.
• If the CD tray is not loaded with a CD/MP3-CD or
the CD/MP3-CD is unreadable, the message “NO
DISC” will be shown.
• For MP3-CD, the disc reading time may exceed 10
seconds due to the large number of songs com-
piled into one disc.
• For MP3-CD, “A” on the display represents ALBUM.
• For MP3-CD, the total album number on the display
indicates the number of all the albums recorded in
the MP3-CD.
Playing a normal disc
1 Press 6 button to start playback.
The track number and elapsed playing time of
the current track appear on the display.
To interrupt playback, press
6 button.
The playing time will start flashing.
To resume playback press
6 button again.
2 To stop playback, press 7 stop button.
Selecting a desired track/passage
To select a desired track
Press 4 or ¢ button (4 or ¢ SEARCH/
TUNING button on the remote control) repeat-
edly until the desired track appears on the display.
• If playback is stopped, press 6 button to start
playback.
• The digit buttons (0~9) on the remote control
can also be used to select a track.
Press the digit buttons as shown below:
To select track 2 : 2 and ENTER
To select track 23 : 2, 3 and ENTER
To select track 120 (MP3-CD only) : 1, 2 and 0
To search for a particular passage during
playback
Press and hold 4 or ¢ button (4 or ¢
SEARCH/TUNING button on the remote control)
and released it when the desired passage is lo-
cated for CD.
Selecting a desired album/file
(For
MP3-CD only)
To select a desired album
Press p.call/album up or down button on the
unit until the desired album number appears on
the display.
• “Axxx xxx” will appear on the display.
To select a desired file
Press 4 or ¢ button (4 or ¢ SEARCH/
TUNING button on the remote control) repeat-
edly until the desired file from the current album
appears on the display.
• “Axxx xxx” will appear on the display.
• The digit buttons (0~9) on the remote control
can also be used to select a file.
continued to next page
*5469/08-20/EN 04.6.1, 11:20 AM 9