Kenwood HM-537MP - Manual (Page 8)

8 EN
Demonstration mode
The system is equipped with a demonstration
function (only display). The demonstration consists
of sequential change of display and indicators
showing the operations, but the audio itself does
not change. The demonstration function can be
cancelled as follows.
To deactivate the demonstration
Press demo button during demonstration.
To activate the demonstration
After turning the power on, press demo button.
Note:
The demonstration operates automatically when a
power failure has occurred, or the plug of the power
cable has been pulled out while the power was on.
Switching the system on
Press button on the unit or POWER button
on the remote control; or CD, TUNER band
(TUNER/BAND on the remote control), or TAPE
mode button (TAPE/MODE on the remote con-
trol).
The standby led will go out.
• The system will switch to the last selected
source or the selected source.
Switching the system to standby
mode
Press button on the unit or POWER button
on the remote control.
• The clock will be displayed.
Volume control
Turn volume knob to the right (press VOLUME
UP
5 button on the remote control) to increase,
or turn volume knob to the left (press VOLUME
DOWN
∞ button on the remote control) to de-
crease the volume level.
“VOL XX” will be displayed. “VOL XX” denotes
the volume level.
The volume can be adjusted in 30 steps from
minimum to maximum.
Basic function
To switch off the volume temporarily
Press MUTE button on the remote control.
Playback will continue without sound only system
speaker output and the icon “MUTE” appears on
the display.
To restore the volume, press MUTE button on the
remote control again or adjust the volume.
Sound control
EQ/X-BASS
The sound control system feature enables you to
enjoy special sound effects that have preset equal-
izer settings, providing the best music reproduc-
tion.
Press EQ/X-BASS button
To select the desired sound effect: POP, CLAS-
SIC, ROCK, JAZZ or FLAT.
To switch the X-BASS on/off
Press and hold the EQ/X-bass button on the unit
(EQ/X-BASS button on the remote control).
If X-BASS is switched on, “BASS ON” will appear
then disappear on the display and the icon “X-
BASS” will appear on the display. If X-BASS is
switched off, “BASS OFF” will appear then disap-
pear on the display and the icon “X-BASS” will
disappear.
Note:
EQ and X-BASS functions are not applied to the record-
ing sound.
Headphones
To listen to your stereo with headphones (not in-
cluded), use the 3.5 mm phones jack on the top
of the unit.
*5469/08-20/EN 04.6.1, 11:20 AM 8