Kenwood HM-537MP - Manual (Page 7)

7 EN
Names and functions of parts
1 CD tray
2 Remote sensor
3 button
To switch the system on or to standby mode.
standby indicator
4 CD button
To select CD input or turn the system on to CD
input.
5 TAPE mode button
To select TAPE input or turn the system on to
TAPE input. When in TAPE input, press to se-
lect a tape reverse mode.
6 TUNER band button
To select TUNER input or turn the system on
to TUNER input. When in TUNER input, press
the select the waveband: FM or AM.
7 search +/– ¢ / 4 buttons
To search forward/backward to next/previous
track for CD; to skip tracks for CD; to search
forward/backward or to skip to the next/previ-
ous album for MP3; to fast forward or rewind
a tape; to tune to higher/lower radio frequency
or search radio stations for TUNER; to set the
hour and minutes for clock; to set timer func-
tion for timer.
8 phones jack
9 7 stop button
To stop playback for CD or TAPE; to stop pro-
gram for CD.
0 6 buttons
To start or interrupt playback for CD. ( 6 but-
ton only)
To start or interrupt playback for TAPE.
! rec button
To record from TUNER or CD to a cassette tape.
@ program button
To program disc tracks for CD; to program pre-
set radio stations for TUNER. To set or reset
clock for clock. To set or reset timer for timer.
# Cassette tape compartment
$ 0 open/close button
To open the CD tray.
% Clock and timer related buttons
timer on/off button
To switch the timer on/off.
timer set button
To view the clock or set the clock.
^ p.call/album down/up buttons
To select a preset radio stations for TUNER.
To select an album of MP3.
& EQ/X-bass button
To select the desired sound effect: POP, CLAS-
SIC, ROCK, JAZZ or FLAT; to switch on/off X-
BASS mode.
* VOLUME knob
To increase or decrease the volume.
( demo button
To activate/deactivate the demonstration in
STANDBY mode.
) push open button
To open the cassette tape compartment.
Standby mode
While the standby indicator is lit, a small amount
of power is supplied to the system to back up the
memory. This is called standby mode. Under the
condition, the system can be turned ON by the
remote control unit.
*5469/01-07/EN 04.6.1, 11:20 AM 7