Kenwood HM-537MP - Manual (Page 15)

15 EN
Using the cassette
4 Press 6 or button to begin recording.
5 Press 7 stop button to end recording.
6 To turn off radio, press TAPE mode button to
TAPE.
Radio recording tip
• To temporarily pause the recording, press rec
button (REC button on the remote control).
Press
6 or button to resume recording.
Recording from a CD/MP3-CD
1 Insert a blank cassette tape into the tape deck.
2 Press CD button to CD.
3 Insert a CD/MP3-CD and select the first track
you want to record.
4 Press rec button (REC button on the remote
control) to set the unit into recording standby
mode.
The icon “REC.” appears on the display.
5 Press 6 or button to begin recording.
The icon “REC.” and the icon “SYNC” will ap-
pear on the display.
The track you have selected in the step 3 will
be played from the beginning.
6 Press rec button (REC button on the remote
control) to interrupt or edit recording. Press 6
or button to resume recording.
7 Press 7 stop button to end recording.
Notes:
• To ensure good system performance, wait until the
unit completely reads the disc before recording.
• During recording, it is not possible to listen to an-
other source.
• You can program tracks and record onto a cassette
tape. If you wish to record only one track, program
that track first, and then record it. (See page 10)
• If you perform the step 4 and 5 during the play-
back of a normal CD, the recording will start from
the beginning of the current track.
During the playback of a MP3-CD, the recording will
start from the point where the step
4 and 5 are
performed.
*5469/08-20/EN 04.6.1, 11:20 AM 15