beautypg.com

2 troubleshooting table, Simple troubleshooting, Troubleshooting table -4 simple troubleshooting -4 – Konica Minolta BIZHUB 164 User Manual

Page 112

background image

Troubleshooting table

11

11-4

bizhub 164

11.2

11.2

Troubleshooting table

Simple troubleshooting

The following explains simple troubleshooting procedures. If the problem is not corrected after the described
operation is performed, contact your service representative.

Description of problem

Check points/Cause

Remedy

The machine does not start up
when the Power Switch is
turned on

Is power being supplied from the
electrical outlet?

Correctly insert the power supply
plug into the electrical outlet.

Has the breaker for the electrical
circuit been tripped?

Close the breaker for the electri-
cal circuit.

Nothing appears on the Display

Is the indicator on the Start key
lit up in green?

The machine has entered the
Sleep mode.
Press any key in the Control
Panel
to cancel the Sleep mode.
(p. 3-3)

Copying does not start

Is the Fusing Unit Top Cover/
1st Side Cover of the machine
open?

Securely close the Fusing Unit
Top Cover
/1st Side Cover of
the machine.

The machine is still warming up
after just being turned on.

The machine takes about 30 sec-
onds to warm up after it is turned
on.
Wait until the machine has fin-
ished warming up.

Is an error message or icon dis-
played on the Display?

Follow the instructions in any
messages that appear on the
Display.

The printed output is too light

Is density set to the lighter side?

Press the ) key (darker) in the
density setting to select the de-
sired density. (p. 5-5)

Is the paper damp?

Replace with new paper. (p. 3-4)

The printed output is too dark

Is density set to the darker side?

Press the * key (lighter) in the
density setting to select the de-
sired density. (p. 5-5)

Was the original not pressed
close enough against the Origi-
nal Glass
?

Position the original so that it is
pressed closely against the
Original Glass. (p. 3-6)

The image is partially obscured
or blurry

Is the paper damp?

Replace with new paper. (p. 3-4)

Was the original not pressed
close enough against the Origi-
nal Glass
?

Position the original so that it is
pressed closely against the
Original Glass. (p. 3-6)

There are dark specks or spots
throughout the printed output
There are streaks in the printed
output

Is the Original Glass dirty?

Wipe the Original Glass with a
soft, dry cloth. (p. 10-9)

Is the Original Pad dirty?

Clean the Original Pad with a
soft cloth dampened with a mild
detergent. (p. 10-9)

Was the original printed on highly
translucent material, such as dia-
zo photosensitive paper or OHP
transparencies?

Place a blank sheet of paper on
top of the original. (p. 3-6)

Is a 2-sided original being cop-
ied?

If a thin 2-sided original is being
copied, the print on the back side
may be reproduced on the front
side of the copy. Press the * key
(lighter) in the density setting to
adjust the density level. (p. 5-5)