Kawai CP115 - Manual (Page 27)

Basic Controls P. 21
• The LED Indicator on the EFFECT and CHORUS buttons will be on only when the active Priority
Part has these effects turned on.
Example
Assume that your CP is set up according to the following chart:
RIGHT1 RIGHT 2 LEFT INDICATOR
Part Inactive Active Active
Effect On On On On
If you then select a different sound for RIGHT2, the Effect setting for the RIGHT1, LEFT will be
turned off automatically. This is because RIGHT2 is the Priority Part (note that the RIGHT1 Part is
NOT the Priority Part because it was inactive).
The chart would now look like this:
RIGHT1 RIGHT 2 LEFT INDICATOR
Part Inactive Active Active
Effect Off On Off On
Even if you now assign a new sound to the RIGHT1 Part, the Effect settings for the other Parts
won’t change, because RIGHT1 is still inactive, so therefore would not have priority.
Once you make the RIGHT1 Part active, however, it would now be considered the Priority Part.
The Effect settings for the other Parts will again be turned off. The Indicator light on the EFFECT
button will now reflect the Effect status for the sound assigned to RIGHT1.
RIGHT1 RIGHT 2 LEFT INDICATOR
Part Active Active Active
Effect Off Off Off Off
At this point, if the Effect that has been called up along with the RIGHT1 sound is one that you’d
like to use for the other Parts, simply select Effect On in the LCD display for those Parts.