Kodak G600 - Manual (Page 46)

40 www.kodak.com/go/support
Maintenance and firmware upgrade
Upgrading your printer dock firmware
IMPORTANT: To upgrade the firmware, your printer dock must be powered by the AC
adapter (not the printer battery).
From your computer
Connect your printer dock to your computer (see page 22 ). Download the latest
version of the printer dock firmware (the software that runs on the printer dock) to
your computer. Visit
www.kodak.com/go/printerdockdownloads .
From your USB flash drive
1 Transfer the latest version of the printer dock firmware file from your computer to
your USB flash drive System or Service folder.
2 Connect your printer dock to the AC power adapter (see page 3 ), and dock your
camera to the printer dock (see page 7 ).
3 Connect the USB flash drive to your printer dock’s USB device connector (see
page 28 ).
The printer dock automatically checks the firmware file version on the flash drive.
4 Press Print, , on your printer dock to begin the firmware upgrade.
To exit the firmware upgrade process, use the buttons on the printer dock to
select Exit on the camera.
5 Follow your camera’s on-screen instructions.
The Red-eye, Transfer, and Print buttons blink until the upgrade is complete. Blinking
stops approximately 5 seconds after the upgrade is complete.
6 Remove the USB flash drive and power your printer dock off, then on again.