Kenwood XD-9581MD - Manual (Page 82)

XD-9581MD (En)
82
Preparation section
Basic section
Application section
Knowledge sections
In case of difficulty
Remedy Cause Symptom
CD player section
÷ Place the disc properly, with the label side
facing upward.
÷ Place the disc properly.
÷ Clean the disc referring to “Disc handling
precautions”.
÷ Try another disc.
÷ Refer to “Beware of condensation” and
remove the condensation by evaporation.
÷ Place a disc in the CD player.
÷ Press the 6 key.
÷ Clean the disc referring to “Disc handling
precautions”.
÷ Try another disc.
÷ Clean the disc referring to “Disc handling
precautions”.
÷ Try another disc.
÷ Install the unit in a place not subject to
vibrations.
A CD is placed in the player but it cannot
be played.
Sound is not produced.
Sound skips.
÷ The disc is placed upside down.
÷ The disc position is displaced.
÷ The disc is extremely dirty.
÷ The disc is scratched.
÷ Dew is condensed on the optics lens.
÷ The disc has not been placed.
÷ The player is not put to the play mode.
÷ The disc is extremely dirty.
÷ The disc is scratched.
÷ The disc is dirty.
÷ The disc is scratched.
÷ The player is subject to vibration.
5
h
)
)
5
5
Remote control unit
Symptom Cause Remedy
Remote control operation is not possible. ÷ Batteries are exhausted.
÷ The remote control is too far away from the
system, the controlling angle is deviated or
there is an obstacle in between.
÷ There is no CD or MD set in the component
to be played.
÷Replace with new batteries.
÷Operate the unit inside the remote control-
lable range.
÷Set a CD or MD in the component to be
played.
&
&