Kenwood DDX7034BT - Manual (Page 76)

76 DNX7140/DNX7000EX/DDX714/DDX7034BT
Setup Menu
DSP Bypass Control
Temporarily bypassing DSP (Digital Signal
Processor) System.
Display the Audio SETUP screen 1
Touch [ ] > [ ] > [Audio SETUP]. (page
63)
Set the DSP Select 2
[Bypass] There is no effect by DSP.
[Through] There is an effect by DSP.
⁄
When the mode is set to [Bypass], DSP System cannot •
be adjusted.
Speaker Setup
You can select a speaker type and its size to get
the best sound effects.
Display the Speaker Select screen 1
Touch [ ] > [ ] > [Audio SETUP] >
[Speaker Select]. (page 63)
Select a speaker you wish to adjust 2
When the speaker type and size are set, the
speaker crossover network and equalizer curve
are set automatically.
2 2 2
1 1 1
3 3 3
1 Front speaker
2 Rear speaker
3 Subwoofer
[Tweeter] You can set the tweeter when you
are selecting front speakers.
If you are using a tweeter together with the
front speakers, set the tweeter to "ON". In the
"ON" position, the Equalizer is adjusted to its
best position.
[X'over] Displays the Speaker Crossover Setup
screen.
You can adjust the crossover setup that was
set automatically when you selected the
speaker type.
Select a speaker type 3
You can select any of the following speaker
types.
"Front" OEM, 4 inch, 5 inch, 6-1/2 inch, 6-3/4
inch, 7 inch, 4x6, 5x7, 6x8, 6x9, 7x10
"Rear" NONE, OEM, 4 inch, 5 inch, 6-1/2 inch,
6-3/4 inch, 7 inch, 4x6, 5x7, 6x8, 6x9, 7x10
"Subwoofer" NONE, 6 1/2 inch, 8 inch, 10 inch,
12 inch, 15 inch over
⁄
Select "NONE" if you have no speakers. •
Crossover Network Setup
You can set a crossover frequency of speakers.
Select the speaker to set the crossover 1
2 2 2
1 1 1
3 3 3
1 Sets the High Pass Filter of the front speaker.
2 Sets the High Pass Filter of the rear speaker.
3 Sets the Low Pass Filter of the sub woofer.
Display the Crossover setup screen 2