Kenwood DDX7034BT User Manual
Page 67
English 67
Monitor Angle Control
You can adjust the position of the monitor.
Display the Angle Setup screen
1
Touch [
]
>
[
]
>
[System]
>
[Angle].
(page 63)
Set the Monitor Angle
2
1
1
1
1 Sets the Monitor angle.
[Memory] Stores the current monitor angle as
the angle during power off.
EXT SW Setup
Setting up power specification of the external
device for which the power is controlled from this
unit.
Display the
1
EXT SW Setup screen
Touch [
]
>
[
]
>
[System]
>
[EXT SW].
(page 63)
Perform EXT SW Setup
2
[SW Name] Sets the name of the external
device. See
information on how to enter the name.
[Output Pattern] Sets the power signal output
mode.
(
EXT SW1: Pulse, EXT SW2: Level)
"Pulse": Generates a single power signal pulse.
"Level": Continues output of high power signal.
Sets to turn output on/off each time
the button on the EXT SW Control
screen is touched.
[Pulse Set] Sets the Pulse signal output time.
Outputs 500ms when "1" is set. Increases by
200ms with each step. Up to 100 steps can
be set.