Kodak EASYSHARE W1020 - Manual (Page 57)

Changing settings and more
www.kodak.com/go/support 51
Automatically upgrade firmware from the Internet
When the frame is connected to your wireless network, you can automatically
upgrade the firmware from the Internet whenever a new version is available.
A message appears on your frame when a new firmware version is detected from the
Internet.
Upgrade right away
■ Install now—Select, then press OK to start the upgrade.
When the upgrade is complete, your frame automatically restarts. If it doesn’t, press the
power switch on the frame to Off, then back to On.
IMPORTANT: Do not turn off the frame during the upgrade!
Upgrade later
■ Remind me later—Select, then press OK.
The upgrade message disappears, then appears again the next time you turn on the
frame.
■ No thanks—Select, then press OK.
The upgrade message disappears. To change your mind and upgrade to this version, see
Manually upgrade firmware, page 50 .
A new message appears when the next firmware version is available.