KTM Super Duke 990s - Manual (Page 8)

ENGLISH
7
OPERATION INSTRUMENTS
»
Setting options in the display
KILOMETERS OR MILES.
You can have the speed and distance shown in kilometers or miles in the dis-
play. The display can be adapted to the respective country on long-distance
trips.
To switch from kilometers to miles, switch on the ignition and press the MODE
[1] button for approx. 10 seconds. The km/h display will switch to mph. The
speed and the stored distances will be converted and displayed in miles.
To return to kilometers, proceed as described above.
CLOCK
Switch on the ignition and change to the CLOCK mode.
Simultaneously press MODE [1] and SET [2]. The numbers on the clock will
start to blink. Use the MODE button to set the hours and the SET button to
set the minutes.
The press the MODE and SET buttons simultaneously.
NOTE:
0:00 will be displayed if the clock is not supplied with electricity. This can
be caused by a defective fuse or a fault in the board electric system (see
Troubleshooting).
TRIP 1
The trip meter 1 runs continuously and counts up to 999.9. It can be used
to measure the length of a certain route on a trip or the distance between two
refueling stops.
To return the trip meter 1 to zero, switch on the ignition, change to the TRIP
1 mode and press the SET button.
RESETTING TRIP 2
The trip meter 2 runs continuously and counts up to 999.9. It can be used
similarly to TRIP 1 or together with a switch available as an accessory (see
below) for trips according to a roadbook.
To return the trip meter 2 to zero, switch on the ignition, change to the TRIP
2 mode and press the SET button.
TRIP F
When the fuel level reaches the reserve mark, the display will automatically
switch to TRIP F and begin to count (no matter which display mode was active
before). At the same time, the fuel warning lamp will start to blink. You will
still have enough reserve fuel for at least 30 kilometers.
After refueling, it will take approx. 8 minutes for the fuel warning lamp to
switch off and for TRIP F to automatically reset to 0 and return to the previ-
ous display mode.
NOTE:
Press the SET key for 2 seconds to immediately turn off the fuel warning lamp.
1 10 sec
1
2
2
2