One-by-one presetting (manual preset), Basic, Receiving broadcast station – Kenwood HD-7 User Manual
Page 24
HD-7/EN
24
Basic
One-by-one presetting (Manual preset)
1 Press the " 7 STOP (AUTO/MONO)" key
during TUNER input.
2 Tune a station.
Tuning to a non-preset radio station (Auto tuning, Manual tuning)
Select the tuning mode according to the radio
wave receiving condition.
When the receiving condition is good:
AUTO mode
When it is poor due to weak radio waves:
MANUAL mode
In AUTO mode :
The next preset station can be received automati-
cally every time the TUNING (
1 or ¡) key is
pressed.
In MANUAL mode :
Press the TUNING (
1 or ¡) key repeatedly until
the desired station is received. The desired station
can also be received by holding the TUNING (
1 or
¡) key depressed until its frequency is displayed.
1 Perform the procedure in "Tuning to a non-
preset radio station (Auto tuning, Manual
tuning)" to receive the station to be preset.
2 Press the ENTER key during reception.
3 Select one of the preset numbers from 1 to 40.
4 Press the ENTER key again.
÷ A maximum of 40 stations of the band presently
being received will be preset.
(Repeat steps
1, 2, 3 and 4 to preset other
stations)
÷ If several stations are preset under the same num-
ber, the previous memory is replaced with the latest
memory contents.
7
STOP
AUTO/MONO
Remote control
Main unit
tuning
1
¡
TUNING
DOWN
UP
Each press alternates the mode.
1 "AUTO"
: Stereo reception
2 "MANUAL" : Monaural reception
÷ In MANUAL mode, FM stations are received
in monaural.
Remote control unit only
ENTER
4
¢
P.CALL
1
2
4
5
6
7
8
9
0
+10
3
or
Receiving broadcast station