Konica Minolta DiMAGE A2 - Manual (Page 128)

1.Turn off the television and the camera.
2.Insert the single plug of the AV cable into the camera’s
AV-out terminal.
3.Plug the other end of the AV cable into the video and
audio input terminal on the television. The yellow plug
is for the video output, and the white plug is for the
monaural audio output.
4.Turn the television on.
5.Change the television to the video channel.
6.Turn on the camera and set the mode switch to the
playback position. The camera’s monitors will not
activate when the camera is attached to a television.
The playback-mode display will be visible on the
television screen.
7.View images as described in the playback section. Use the television controls to adjust
the volume of the audio playback. Because of the broadcast standard used to display
television images, image quality and resolution will appear lower than when displayed
on a computer monitor.
128 A DVANCED PLAYBACK
VIEWING IMAGES ON A TELEVISION
It is possible to view camera images on your television. The camera has a video-out
terminal which can be used to connect the camera to a television using the supplied AV
cable. The camera is compatible with the NTSC and PAL standards. The video-output
setting can be checked and set in section 1 of the setup menu (p. 129).
2
3
6