Kodak EasyShare 5100 - Manual (Page 8)

Chapter 1
Status Lights
The following tables contain information on the EasyShare AiO lights.
Control Panel
Light Status Cause Action/Solution
The printer is turned off. Press the On/Off button to turn
the printer on. All lights and displays are off.
The Printer does not have power
applied. Check the Power Cord Light
status.
All lights Flash once. The Printer is Initializing. None: Allow the Printer to finish
the initialization process.
All lights are flashing and the
On/Off Light is flashing yellow. The Printer has detected an
error condition. Disconnect power for 5 seconds
and reconnect power. If the
condition persists, please check
the 8 Segment Display for
additional codes. Contact Kodak
for assistance.
Power Light on Power Cord
Light Status Cause Action/Solution
The printer to power supply cord
is not properly connected to the
Power Supply. Reseat the printer to power
supply cord.
The power supply to your wall
outlet cord is not properly
connected to your wall outlet. Reseat the Power Supply to your
Wall Outlet Cord.
You do not have the appropriate
power available at your wall
outlet. Test your wall outlet by plugging
a known working device into you
wall outlet. Have your wall outlet
checked by a qualified
electrician.
Power cord light is off.
There may be an issue with the
power supply. Visit Kodak.com for additional
troubleshooting steps or contact
your local Kodak Call Center.
Power cord light is on. The power cord and power
supply are properly connected
and ready to supply power to the
printer. Ensure that the power cord in
properly plugged into the back of
the printer.
4 Kodak EasyShare 5100 AiO