Kenwood HD Radio TUNER - Manual (Page 13)

English | 13
Mounting the HD Radio tuner unit
Installation using the self-tapping
screws
Installation using the velcro tapes
Please do not install the unit near the dashboard,
the rear tray, or other important components.
Doing so could lead to injury or accident should the
unit come off due to a shock and strike a person or
an important component.
Tapping screws should be used for mounting.
(Attachment with velcro strips, although easy, can
come off with a shock.)
• Install the HD Radio tuner unit in a well-ventilated
location and do not place objects on top of it.
• When installing to the car, the unit should be
securely fastened at a location that will not
interfere with driving.
• When making a hole in the chassis, check that the
gas tank, break pipe, wire harness, or other part is
not located on the other side, and be careful not
to cause scratches.
• When attaching the mounting fittings
(Accessory 2) to the HD Radio tuner unit, use only
the supplied mounting screws (Accessory 3) (M4
× 8 mm). Use of screws other than those supplied
may result in internal damage or insecure
mounting and is very dangerous.
Carpet
Board etc.
thickness: 20 mm or more
Accessory 4
(Ш5 Ч 20 mm)
Accessory 2
Accessory 3
(M4 × 8 mm)
Carpet
Accessory 5