Kenwood HM-335 - Manual (Page 19)

Playback of TAPE
19 EN
To wind tape at high speed
÷ Press the STOP 7 key to stop fast winding.
÷ The same operation is also available with the 4
and ¢ keys on the main unit.
Selection of TAPE equalizer (TAPE EQ.)
When playing a tape prerecorded with Noise Re-
duction system (such as the DOLBY NR) ON, be
sure to set the "TAPE EQ." ON for playback.
Each press switches the modes as follows.
1 "TAPE EQ." lights
( TAPE equalizer is used)
2 "TAPE EQ." goes off
( TAPE equalizer is not used )
Lit when "TAPE EQ." is ON
÷ Select the "TAPE EQ." ON mode according to the
recording condition of the tape.
Selection of reverse mode
To stop playback
The tape counter is set to "0000" when a cassette
tape is loaded. By writing down the counter read-
ing in case you want to interrupt recording (play-
back) in the middle of the tape, the memo will be
helpful as a reference for locating the same posi-
tion when continuing the recording (playback) the
next time. The tape counter figure decreases dur-
ing recording or playback of the back side (while
the
2 tape transport indicator is lit). To set the tape
counter to "0000", open the cassette holder once.
Then the counter will be reset.
A tip for use of the tape counter
1
Select "TAPE RVS".
2
Select.
3
Set it.
1 " " : (ONE-WAY)
Only one side is played back (recorded), and
then the tape stops.
2 " " : (REVERSE)
Both sides are played back (recorded), and
then the tape stops.
3 " " : (ENDLESS)
Both sides are played back endlessly. (The
tape stops after recording onto both sides.)
(The initial setting is " "(REVERSE))
Main unit only To fast wind in
direction
\
To fast wind in
direction
|
1 1
TUNING
TAPE EQ.
STOP 7
AUTO/MONO
\ \ \ \
mode set/sound
set/sound