Sennheiser SK 5212 - Manual (Page 25)

24
Adjusting the microphone sensitivity – ATTEN
Via the “ ATTEN ” menu, you can adjust the transmitter’s sensitivity.
Adjusting the bass roll-off frequency – LOWCUT
To reduce unwanted low-frequency noise such as wind and handling noise,
you can activate a low-cut filter. The low-cut frequency is 1 20 Hz.
If you do not want to reduce low-f requency signal por tions, select the set-
ting “FLAT”.
Selecting the standard display – VIEW
Via the “ VIEW ” menu, you can select one of the fol lowing standard displays:
The selected standard display is shown
!
after switch-on,
!
after the menu settings have been displayed f or 10 seconds in display
mode.
The sensitivity is correctl y adjusted when the level
display for audio signal “AF”
ቨ
shows full
deflection only during the loudest passages or
when the r edLED
·
lights up brightly.
The sensitivity can be adjusted in 1-dB steps from
+ 40 dB to –30 dB.
Note:
!
The bargr aph has a resol ution of appr ox. 3 dB
per segment with a display r ange of 45 dB.
Transmission
f requency “
FREQ ”
Channel
“ CHAN ”
Name
“ NAM E ”
dB
AF
RF
ቨ
·
RF
MHz
CH
CH
RF RF