Sharp XG-C50X - Manual (Page 72)

-70 -70
Remaining Lamp Life
(Percentage)
Displaying the Remaining Lamp Life (Percentage)
Checking the Remaining
Lamp Life (Percentage)
This function allows you to check the remain-
ing lamp life (percentage).
Select the “Options (2)” menu on the
menu screen.
➝ For operating the menu screen, see
pages
42 to 45 .
Note
• It is recommended that the lamp be
changed when the remaining lamp life
becomes 6%.
For lamp replacement, contact your
nearest Shar p Authorized Projector
Dealer or Service Center.
• The table at the right indicates rough esti-
mates in the case of using only in each mode
shown. Remaining lamp life changes within
the range of the values shown depending
on the frequency at which “Power Save” is
switched “ON” and “OFF” (see page
69 ).
Automatic Power Off
Function
When no input signal is detected for more than
15 minutes, the projector will automatically
power off if set to “ON”.
The Auto Power Off function will be disabled
when it has been set to “OFF”.
Select “Auto Power Off” in “Economy
Mode” under the “Options (1)” menu on
the menu screen.
➝ For operating the menu screen, see
pages
42 to 45 .
Note
• When the Auto Power Off function is set
to “ON”, 5 minutes before the power turns
off, the message “Power OFF in X min.”
will appear on the screen to indicate the
remaining minutes.
-70
Selecting the Economy Mode
Remaining lamp life
100% 6%
2,000 hours 133 hours
1,500 hours 100 hours
Used with only “ON”
on “Power Save”
(Low power mode)
Used with only “OFF”
on “Power Save”
(Standard mode)