Using the remote control, Inserting the batteries, Available range of the remote control – Sharp XG-C50X User Manual

Page 15

Introduction

-13

23' (7 m)

Using the Remote Control

■ The remote control can be used to control the projector

within the ranges shown in the illustration.

Note

• The signal from the remote control can be reflected off a screen

for easy operation. However, the effective distance of the signal
may differ due to the screen material.

When using the remote control:

• Be sure not to drop, expose to moisture or high temperature.

• The remote control may malfunction under a fluorescent lamp.

Under that circumstance, move the projector away from the fluo-
rescent lamp.

Inserting the Batteries

The batteries (two R-6 batteries (“AA” size,
UM/SUM-3, HP-7 or similar)) are included in
the package.

Pull down the tab on the cover
and remove the cover towards
the direction of the arrow.

Insert the included batteries.

• Insert the batteries making sure the

polarities correctly match the

and

marks inside the batter y

compartment.

Insert the lower tab of the
cover into the opening, and
lower the cover until it clicks
in place.

Incorrect use of the batteries may cause them to leak or explode. Please follow the precautions below.

Caution

• Insert the batteries making sure the polarities correctly match the and marks inside the battery compart-

ment.

• Batteries of different types have different properties, therefore do not mix batteries of different types.

• Do not mix new and old batteries.

This may shorten the life of new batteries or may cause old batteries to leak.

• Remove the batteries from the remote control once they have run out, as leaving them can cause them to leak.

Battery fluid from leaked batteries is harmful to your skin, therefore be sure to first wipe them and then remove
them using a cloth.

• The batteries included with this projector may exhaust over a short period, depending on how they are kept.

Be sure to replace them as soon as possible with new batteries.

• Remove the batteries from the remote control if you will not be using the remote control for a long time.

Remote
control
sensor

Remote control
signal transmitters

Remote control

Available Range of the Remote Control