Star Micronics SP300 - Manual (Page 53)

– 49 –
7-6. Control Codes Used for Peripheral Units
FUNCTION Adjust drive pulse width for peripheral unit 1
CODE n1 n2
(1B)
H
(07)
H
n1 n2
DEFINITION RANGE 1 n1 127, 1 n2 127 (default setting n1 = n2 = 20)
OUTLINE Adjusts drive pulse width for peripheral devices requiring
other than standard 200 ms pulse time and delay time
Energizing time = 10
×
n1 (ms)
Delay time = 10
×
n2 (ms)
Executed by , codes.
NOTE Adjustment is not necessary for standard cash drawers in the
U.S.A. market.
FUNCTION Deferred drive command for peripheral unit 1
CODE
(07)
H
OUTLINE Executes drive pulse for peripheral unit 1 (deferred).
FUNCTION Immediate drive command for peripheral unit 1
CODE
(1C)
H
OUTLINE Executes drive pulse for peripheral unit 1 (immediate).
This code differs from the code as follows:
When the printer receives an code, the command is
executed immediately. The code is stored in the data
buffer in the same manner as other codes, and executed in the
order in which they are received.
ON
OFF
10
×
n 1 (ms) 10
×
n 2 (ms)
Printing and paper feed
are prohibited.