Star Micronics SP300 - Manual (Page 33)

– 29 –
7. CONTROL CODES
Control Codes Used for Character Setting
Control codes
Hexadecimal
Function Page
codes
“R” n 1B 52 n Select international character set 32
“6” 1B 36 Select IBM character set #2 32
“7” 1B 37 Select IBM character set #1 32
“M” 1B 4D Select 7
×
9 (half dot) font 33
“P” 1B 50 Select 5
×
9 (2 pulses + 1 dot) font 33
“:” 1B 3A Select 5
×
9 (3 pulses + 1 dot) font 33
0E Select expanded character mode 33
14 Cancel expanded character mode 34
“W” “1” 1B 57 31
Select expanded character mode 34
“W” <1> 1B 57 31
“W” “0” 1B 57 30
Cancel expanded character mode 34
“W” <0> 1B 57 30
“E” 1B 45 Select emphasized print mode 34
“F” 1B 46 Cancel emphasized print mode 34
“-” “1” 1B 2D 31
Select underline mode 35
“-” <1> 1B 2D 01
“-” “0” 1B 2D 30
Cancel underline mode 35
“-” <0> 1B 2D 00
“_” “1” 1B 5F 31
Select upperline mode 35
“_” <1> 1B 5F 01
“_” “0” 1B 5F 30
Cancel upperline mode 35
“_” <0> 1B 5F 00
“4” 1B 34 Select highlighted print mode 35
“5” 1B 35 Cancel highlighted print mode 36
0F Select inverted print mode 36
12 Cancel inverted print mode 36
Control Codes Used for Line Spacing
Control codes
Hexadecimal
Function Page
codes
0A Line feed 36
0D Line feed (same as LF) 36
“z” “1” 1B 7A 31
Set 1/6-inch line feed 36
“z” <1> 1B 7A 01
“0” 1B 30 Set 1/8-inch line feed 37
“a” n 1B 61 n Feed paper n lines 37