Adding idd code to the incoming calls, Adding prefix mark to the calls, Adjust the lcd light – Siemens W12 User Manual
Page 8: Selecting ringer tones
Gigaset 4010 Comfort, CHIN eng, A31008-G4010-C102-1-7619 umschl_v.fm 16.10.03
Adding IDD code to the incoming calls
For example, an incoming call display is “13928389222”, after set the
international direct dial (IDD) code as “0”, will be “013928389222”
because the telephone add a “0” before the incoming number.
Press the Mem/Prog key for 2 seconds
Press Channel/Select key until “Lo CodE” appears
Enter one digit of IDD code, which can be deleted by pressing the
Flash/Clear key.
Press Mem/Prog key for confirmation
Press Exit to exit
Adding prefix mark to the calls
Press the Mem/Prog key for 2 seconds
Press the Channel/Select key until “Add” appears
Enter one digit of “9”. (For example, you need to enter “9” for placing
outgoing calls. When placing an outgoing call, you must enter “9” before
dialing out.)
Press the “Mem/Prog”(ᄬټ/䆒㕂) key for confirmation
Press Exit to exit
Adjust the LCD light
Press the Mem/Prog key for 2 seconds
Press the Channel/Select key until “LCD” appears
Press Ʒ or ͩ to adjust the light
Press the Mem/Prog key for confirmation
Press Exit to exit
Selecting Ringer Tones
Press the Mem/Prog key for 2 seconds
Press the Channel/Select key until “Ring” appears
Press Ʒ or ͩ to select the ringer melody. (8 melodies)
Press the Mem/Prog key for confirmation
Press Exit to exit
8