Sanyo PLC-SW30 - Manual (Page 37)

37
Setting
For reducing power consumption as well as maintaining the lamp
life, the Power Management function turns off the projection lamp
when the input signal is interrupted and no button is pressed for 30
seconds or more.
If the input signal is interrupted and no button is pressed for 30
seconds or more, the timer display with the message " No signal "
appears on the screen. The count-down of the set time will get
started. The count-down time can be set between 1 and 30
minutes.
When the count-down time has been elapsed, the lamp will be
turned off to cool itself down. The POWER indicator is flashing red
during this cooling-off period. The next operation depends on the
setting as follows :
Ready . . . . . . . . When the lamp has been fully cooled down, the
POWER indicator changes to green flashing. In
this condition, the projection lamp will be turned
on if the input signal is reconnected or any
button on the top control or remote control is
pressed.
Shutdown . . . . . When the lamp has been fully cooled down, the
power will be turned off.
Off . . . . . . . . . . . The Power Management function is canceled.
Power management
Ceiling
When this function is “On,” picture is top / bottom and left / right
reversed. This function is used to project the image from a ceiling
mounted projector.
Rear
When this function is “On,” picture is left / right reversed. This
function is used to project the image to a rear projection screen.
Ceiling function
Rear function
Time left until Lamp off
Press the SELECT button at Power
management to show this box.
Choose one of three settings with the
Point
7 8 button, and navigate to the
timer with the Point ed button and
set time with the Point 7 8 button.
Power management
Lamp mode
This function allows you to change brightness of the screen.
···· normal brightness
···· the controlled brightness according with input signal
···· lowers brightness, reduces the lamp power consumption,
and extends the lamp life.
Lamp mode
Press Point 7 8 buttons to
select lamp mode.