Sanyo PLC-SW30 - Manual (Page 13)

13
Preparation
Positioning the Projector
– This projector is designed to project on a flat projection surface.
– The projector can be focused from 4.3’(1.3m) to 21.3’(6.5m).
– Refer to the figure below to adjust a screen size.
40”
100”
150”
200”
169”
127”
83”
34”
A
B
21.3’ (6.5m)
16.1’ (4.9m)
10.6’ (3.2m)
4.3’ (1.3m)
Max. Zoom
Min. Zoom
A : B = 9 : 1
Screen Size
(W x H) mm
4 : 3 aspect ratio
Zoom (min)
40”
Zoom (max)
813 x 610
4.9' (1.5m)
4.3’ (1.3m)
100”
2032 x 1524
12.5' (3.8m)
10.6’ (3.2m)
150”
3048 x 2286
19.0' (5.8m)
16.1' (4.9m)
200”
4064 x 3048
–––––
21.3’ (6.5m)
34"
691 x 518
4.3’ (1.3m)
–––––
Note:
The brightness in a room has a great influence on picture
quality. It is recommended to limit ambient lighting in order
to provide the best image.
Center
Adjustable Feet
Picture tilt and projection angle can be adjusted by rotating the
adjustable feet. Projection angle can be adjusted at 8.0 degrees.
Lift the front of the projector and pull the feet lock latches on
the both sides of the projector. 1
Adjustable Feet
Feet Lock
Latches
Release the feet lock latches to lock the adjustable feet and
rotate them to adjust position and tilt. 2
To retract the adjustable feet, lift the front of the projector
and pull and undo the feet lock latches.
Keystone distortion of the projected image can be adjusted
by Menu Operation. (
☞
P20 and P36 )
3
CAUTION
Tilt the projector within the adjustable angle not to shorten the lamp life.
Proper angle should be taken.