Sanyo PLC-SW30 - Manual (Page 15)

15
S-VIDEO
COMPUTER IN /
COMPONENT IN /
COMPUTER /
COMPONENT
AV
AUDIO IN
VIDEO
USB
SERVICE PORT
RESET
Connecting to a Computer
IBM-compatible computer or Macintosh computer (VGA / SVGA / XGA / SXGA)
Note :
When connecting the cable, the power
cords of both the projector and the external
equipment should be disconnected from
AC outlet. Turn the projector and peripheral
equipment on before the computer is
switched on.
Installation
ON ON
ON
1
DIP
ON
OFF
2 3 4 5 6
13" MODE (640 x 480)
16" MODE (832 x 624)
19" MODE (1024 x 768) OFF
ON
ON
OFF OFF OFF
OFF OFF OFF
OFF OFF OFF
3 4 5 6
OFF OFF ON ON 21" MODE (1152 x 870)
ON ON
ON
ON
OFF
OFF
1 2
ON ON
Set switches as shown in the
table below depending on RES-
OLUTION MODE that you want
to use before you turn on pro-
jector and computer.
◆ MAC ADAPTER (Not supplied) ✽
VGA Cable USB
Cable
✽
Audio Cable
(Stereo)
✽
USB port Audio Output Monitor Output
Terminals of the Projector
Cables used for connection
• VGA Cable ( HDB 15 pin )
• Audio Cable ( Mini Plug (stereo) )
✽
• USB Cable ✽
• MAC Adapter ( For Macintosh ) ✽
✽ Not supplied.
If you wish to use Page ▲▼ buttons on
the remote control, connect USB port of
your computer to the USB socket of the
projector. (
☞
P10, P38 )
A Macintosh adapter may be required when you use a
Macintosh computer.