Southbend 14" Turn-X Toolroom Lathe SB1039 - Manual (Page 61)

For Machines Mfg. Since 5/11 14" TURN-X ® Toolroom Lathe
-59-
O P E R A T I O N
1 ⁄
4
or 3 ⁄
4
Fractional TPI
For TPI that have a 1 ⁄
4
or 3 ⁄
4
fraction, use position
1 on the thread dial (see Figure 85).
2 7 ⁄
8
TPI
The thread dial is not used for 2 7 ⁄
8
or metric
threading, or diametral and modular pitches (see
Figure 86). The half nut must stay engaged with
the leadscrew throughout the entire threading
operation.
Figure 85. Position for 1 ⁄
4
or 3 ⁄
4
fractional TPI.
Position
1 Only 2¼,2¾,
3¼,3¾
TPI
Figure 86. Half nut stays engaged for 2 7 ⁄
8
TPI.
2 7 ∕
8
Same as
Metric
Threads
Thread Dial
Not Used
The chip drawer catches swarf and metal chips
during the machining process. It contains a
screen that keeps the large chips from returning
to the reservoir with the run-off coolant—this
prevents the chips causing pump damage.
Also, it slides open and is removable for cleaning
(see Figure 87).
Chip Drawer
Figure 87. Chip drawer.
The chip drawer is very heavy. Unless
removing the chip drawer for cleaning, do
not pull it out more than halfway to prevent it
falling and causing impact injuries. If removing
the drawer for cleaning, get assistance!