Setting up the channel list - initial setup – Sony GRAND WEGA KDS-R70XBR2 User Manual
Page 26
Getting Started
26
KDS-R60XBR2/KDS-R70XBR2
2-699-721-11(1)
F:\Worker\SONY SXRD-R\2699721111(062606)\020GET.fm
masterpage:3 columns Right
Setting Up the Channel List - Initial Setup
After you finish connecting the TV, you can run the Initial Setup to create a
list of available analog and digital channels. The Initial Setup screen
appears when you turn on the TV for the first time after hooking it up.
1
Press POWER on the TV front panel to
turn on the TV.
The Initial Setup screen appears.
2
Press
V/v to highlight the on-screen
display language, then press
.
The Date and Time screen appears.
3
Press
V/v to change the numbers, and B/b to move between fields.
4
When you finish setting the date and time, highlight “OK” and press
.
The message “Start auto program now?” appears.
5
Press
V/v to highlight “Yes” then press
.
Auto Program performed through Initial Setup will automatically create a
list of receivable channels from both VHF/UHF antenna and cable TV
channels if both sources are connected.
If you choose to set up the channels at a later time, select the Auto Program
option in the Channel settings to scan available channels (see page 56).
After Auto Program is complete, you will be prompted to set up the TV
Guide On Screen system.
6
After Auto Program is complete, press
to proceed to the TV Guide
On Screen system setup.
7
When the Welcome screen appears, press
again to begin the setup.
✍
If you select “No” during Initial Setup, the Initial Setup screen will
reappear each time you turn on the TV until you complete Auto
Program.
✍
Make sure you finish Auto Program before starting the TV Guide On
Screen system setup. If Auto Program is not completed, you may not be
able to correctly receive program listings.