Sony 3CCD COLOR BRC-300P - Manual (Page 54)

A
pp
end
ix
List of Messages
54
Appendix
List of Messages
The following messages may appear on the screen. Take
the necessary measures shown below.
Indicators on the BRC-300/300P camera
Messages for the BRC-300/300P camera
Error messages for the BRU-300/300P Optical
Multiplex Unit
Indicator Meaning/remedies
STANDBY lamp
flashes. The camera stopped moving due to an
error in the pan/tilt mechanism. Reset
the pan/tilt position or turn off the power
of the camera and turn it on again.
The tally lamp
flashes. Turn off the power of the camera, and
consult with your Sony dealer.
Message Meaning/remedies
Please restart system You are prompted to restart the power of
the camera after you changed the setting
of "IMG-FLIP" in the SYSTEM menu or
"D-ZOOM" in the PAN TILT ZOOM
menu.
Use the POWER switch on the supplied
Remote Commander or the POWER
button on the RM-BR300 Remote
Control Unit to turn the power off, then
on. The changed setting becomes
effective.
PRESET xx OK
(xx = 1 to 6) When you store the camera settings into
the memory (POSITION 1-6), the
message will appear for 2 seconds.
White balance active While the white balance adjustment is
automatically adjusted, the message will
blink. Wait for a while. When the
adjustment is complete, it will disappear.
White balance active
Please wait The message will appear only when you
activate the one-push white balance
adjustment by pressing the ONE PUSH
AWB button on the RM-BR300 Remote
Control Unit.
Message Meaning/remedies
Communication error
Please check
connection The message will appear when the
Optical Multiplex Unit is turned on, if a
problem occurs in the connection of the
Optical Fiber Cable between the camera
and the Optical Multiplex Unit. Turn off
the power of the camera and the Optical
Multiplex Unit, check the connection of
the Optical Fiber Cable and turn the
power on again.
Option card error
Please check option
card The message will appear when same-
type interface cards are inserted into the
two card slots on the Optical Multiplex
Unit. Turn off the power of the Optical
Multiplex Unit and remove either of the
cards.