Sony 3CCD COLOR BRC-300P - Manual (Page 42)

In
s
ta
llat
ion
a
nd
Conne
c
tio
ns
Installation
42
Installation and Connections
Installation
Attaching an Interface Card
Attach an interface card (not supplied) to the card slot on
the rear of the camera.
1
Loosen the two screws to remove the card slot
cover.
2
Insert an optional interface card into the card slot.
Align both ends of the interface card with the
sliders inside the slot, then insert the card securely
as far as it will go.
3
Tighten the two screws on the interface card.
To remove the interface card
Loosen the two screws on the interface card and pull the
card out straight and slowly.
Installing the Camera
To install the camera on a desk
Place the camera on a flat surface.
If you have to place the camera on an inclined surface,
make sure that the inclination is less than ±15 degrees,
so that the pan/tilt performance is guaranteed, and take
an appropriate countermeasure to prevent the camera
from falling.
Notes
• Do not grasp the camera head when carrying the
camera.
• Do not turn the camera head by hand. Doing so will
result in the camera malfunctioning.
Interface card
(not supplied)