Star Trac S-UBX - Manual (Page 40)

40
620-7992 Rev 001
Headphone Jack Replacement.
When you are experiencing poor audio output from your PVS, you should check the entertainment
headphone jack to see if it needs replacement. The headphone jack was designed for an easy and
quick replacement.
Before you begin, make sure your have the proper replacement part available.
For the S-TR use part number 740-6014.
For the S-TBTx, S-RBx, and S-UBx use part number 740-0012.
For the S-TR Model:
1. Use a #2 Phillips screwdriver to remove the
screw that holds in the headphone jack at the
lower front of the display.
2. Gently pull the headphone jack out of the display.
Be careful, the headphone is connected to a ca-
ble.
3. Disconnect the cable.
4. Connect the new headphone jack to the cable in
the jack opening.
5. Slide new headphone jack into the display plastic
front.
6. Using the screwdriver, re-install the screw.
For the S-TBTx, S-RBx, and S-UBx Models:
1. Using a pair of pliers, pull the headphone jack out
of the display. Be careful, the headphone is con-
nected to a cable.
2. Disconnect the cable.
3. Connect the new headphone jack to the cable in
the jack opening.
4. Slide new headphone jack into the display plastic
front.
This completes the headphone jack replacement.
Screw
Headphone Jack
Headphone
Cable
Bottom Cover
Headphone Adaptor
Location
Headphone Adaptor
Headphone Plug