Star Trac S-UBX - Manual (Page 13)

13
620-7992 Rev 001
STEP 3.
Now, replace the TV keypad on the front dis-
play. Carefully remove the label of the center
console with a flat screw driver. And then, re-
move the (4) screws that hold the center con-
sole in place. Retain all the screws for later
use.
STEP 1.
Using a #2 Phillips screwdriver, remove the (19)
screws that hold the back cover of the display.
Next, remove the back cover and the upper cap
cover with “Star Trac Logo” on it (You will no
longer need this cap cover and, if desired, you
can store it away for any possible future use).
Retain all the screws for later use.
STEP 2.
Take the PVS from its package and remove the
bubble wrap. Insert the PVS into the rectangle
tube on the back of the treadmill. Adjust the
new cap into place, (make sure it is below
handrail), then fasten with (2) M8 screws and
(2) washers.
Note: Keep all (4) cables on the right side.
I
NSTALLING
Y
OUR PVS
O
N
T
HE
S
-TRc
A
ND
S
-TRx
Screws
Cap
Back
Cover
(4) Screws
CENTER
CONSOLE
LABEL, CENTER
CONSOLE
Cap
(4) Cables
Screws and
washers