Star Trac S-UBX - Manual (Page 11)

11
620-7992 Rev 001
STEP 4.
Replace the TV control pad:
•
Using a #2 Phillip screwdriver, fasten the TV con-
trol pad with the (3) screws and install the wire-
less HR receiver back to the same location.
•
Plug in the TV keypad connector into JP5
•
Plug in the interface control connector into JP4
•
Plug in the power-in connector into JP7
•
Plug in the power-out connector into JP6
STEP 5.
Using a pair of pliers, remove the IR-Reader
plastics from the bottom cover, and replace it
with the headphone adaptor. And then, plug in
the 90° angle headphone plug as shown.
STEP 6.
Install the bottom cover back and secure using
the (9) screws you saved from earlier step.
Polar Receiver TV Keypad Cable
Interface Control
(5-Contacts)
Power-out
Power-in
Bottom Cover
IR-Reader
Headphone Adaptor
Headphone Plug