Star Trac S-UBX - Manual (Page 35)

35
620-7992 Rev 001
Adjusting Channel Menu Options
Auto Channel Search
1. Press VOL+, CH+ and the number [3] at the same time,
the main menu screen should be displayed.
2. Press VOL+/- to select Channel menu, press CH- to ac-
cess the menu.
3. Highlight Auto Tuning item, and press VOL+ or OK to ac-
cess.
4. Now a confirmation box appears on the screen. Press
VOL+/- to select a country firstly, press CH- or OK to high-
light Start item, and then press OK to begin the auto chan-
nel search. (If you want to cancel, press VOL+/- to select
Cancel item, and use.
5. Then the TV begins memorizing all ATV/DTV channels
available in your area. During the process, you can press
VOL+, CH+ and number button [3] at the same time to
skip the search.
If desired digital programs cannot be searched by Auto Tun-
ing, you can make use of DTV Manual Tuning to search pro-
grams manually.
1. In Channel menu, press CH+/- to select DTV Manual
Tuning item, then press VOL+ or OK to access.
2. Highlight VHF CH (or UHF CH) item, press VOL+/- button
to select your desired channel number.
3. Press OK to begin the manual DTV channel search.
At the bottom of the menu screen the DTV Signal strength
bar is displayed. You can make use of it to check how strong
your DTV signal is and whether you need to adjust your an-
tenna or digital cable input. The higher the signal strength is,
the less likely you are to experience picture degradation.
4. Then all the digital programs available in this channel will
be searched and stored. During the process, you can
press VOL+, CH+ and number button [3] at the same time
to exit the search.
When you turn on the unit for the first time, you should perform an auto channel search to set up stations on
your unit.
You should perform an auto channel search to search for all channels available and stores them in memory, before
you start Auto Tuning, it is necessary to select a country firstly.
Manual Searching for DTV programs