Woodstock W1814 - Manual (Page 30)

-28-
N(/(+Fne\ijDXelXcD]^%('&'/"
J
M
@:<
-% Loosen the fence tilting handle, bring the fence
to 90º with the square set against the fence, then
tighten the handle.
Efk\1B\\gk_\c`d`kgcXk\kXY`ek_\i\Xijcfkf]
k_\c`d`kYcfZb%
.% Loosen the jam nut (located at the rear of the limit
block shaft).
/% Using a screwdriver, turn the limit block set screw
until the limit block shaft hits the fence.
0% Tighten the jam nut. The 90º stop is now set
precisely.
=`^li\42. Checking the inward 45º stop.
=`^li\43. Adjusting the inward stop.
Kfj\kk_\`enXi[+,²jkfg#[fk_\j\jk\gj1
(% DISCONNECT JOINTER FROM POWER SOURCE.
)% With the fence positioned over the bed and the
sliding handle locked, loosen the fence tilting handle
and release the limit tab.
*% Tip the fence towards the table as far as it will go,
then tighten the fence tilting handle.
Efk\1 N_\epflk`gk_\]\eZ\kfnXi[jk_\kXYc\#`k
n`ccjkfgn_\e`k_`kjk_\`enXi[jkfgYfck%
+% Use a machinist's combination square to check the
angle of the fence, as shown in =`^li\42.
— If the fence leans 45º towards the table, the
inward 45º stop is set correctly; move ahead to set
the outward 45º stop.
— If the fence does not lean 45º towards the table,
adjust the inward 45º stop by doing Jk\gj,$0.
,% Loosen the fence tilting handle, bring the fence to
45º, then tighten the handle just enough to keep the
fence in position.
-% Remove the limit block from the fence bracket
assembly and set it aside.
.% Using two 8mm wrenches, adjust the inward stop
bolt (see =`^li\43)until it hits the fence at
precisely 45º inward, then tighten the jam nut
(where the bolt meets the bracket assembly) while
holding the stop bolt in place. Some trial-and-error
will be required to set this stop correctly.
Inward
Stop Bolt